KJT speed control switch products are mainly developed according to the actual needs of customer sites. The products have a wide range of electricity, and can be applied to 24VDC─110VAC─220VAC (different voltage levels are configured with intermediate relays of different voltages), bringing unified purchasing to users. Easy installation and good interchangeability. The product can effectively and timely handle electrical and process failures such as stalling, jamming, overloading, slow rotation, belt slipping, transmission chain (belt) falling off, transmission shaft breakage, etc. that often occur in motors and mechanical transmission devices. It can play a role in ensuring production and maintaining equipment.
| Product Paramenters | |
| application | Evaluation of rotational and linear motion speeds below preset values, blockage |
| Switch function | The output switches during the start-up delay if (Factual) is greater than (Fpreset) |
| Electrical Design | DC PNP |
| Switching output | Normally open/normally closed programmable |
| Nominal voltage [V] | 10-36V DC |
| Current consumption [mA] | <15 |
| Protection level | II |
| Reverse polarity protection | YES |
| Rated current [mA] | 250 / 15 |
| Voltage drop [V] | < 2.5 |
| Short circuit protection | pulse |
| Overload protection | YES |
| Minimum load current [mA] | 12 |
| Correction coefficient | Mild steel = 1 / stainless steel approx. 0.8 / brass approx. 0.5 / aluminum approx. 0.4 / copper approx. 0.3 |
| Setting range [pulses/minute] | 3-6000 |
| Adjustment of switch point | Teaching function |
| Hysteresis [% of Sp] | 10 |
| Start delay [s] | 0-15 |
| Damping frequency (maximum) [pulses/min] | 18000 |
| Ambient temperature [°C] | -20~80 |
| Protect | IP67 |
| Electromagnetic Compatibility | EN 60947-5-2 |
| Average time TF [a] | 1031 |
| Install | Non-Flush |
| Shell material | Stainless steel 316Ti / 1.4571; polystyrene |
| Weight [kg] | 0.065 |
| Operation indicator light | Green |
| Input pulse indicator light | Green |
| Output status indicator light | Yellow |
| connect | M12 connector; gold plated contacts |
| Remark | 1.Factory settings 2.cULus - Type 2 source required 3. Switching output/pulse output |
| Packing quantity [pieces] | 1 |